Behavior and process of background signal formation of hydrogen,carbon, nitrogen,and oxygen in silicon wafers during depth profiling using dual-beam TOF-SIMS

The behavior and mechanism of background signals during depth profiling of atmospheric elements using dual-beam time-of-flight secondary ion mass spectrometry (TOF-SIMS) have been experimentally investigated for silicon wafers. The background signals of atmospheric elements were found to be inversely proportional to the sputtering rate. Most of the background signals are largely attributable to the accumulation of components through adsorption and ion bombardment in the pre-equilibrium state. On the other hand, the contribution of real-time adsorption during the instant after the last sputtering in the equilibrium state is negligible under the present experimental conditions. H₂O is dominant in the background formation process of hydrogen and oxygen, which is supported by the higher adsorption coefficients. The background levels of carbon and nitrogen are lower than those of hydrogen and oxygen. Furthermore, the background signal of carbon with respect to the sputtering rate shows a different trend than the other elements. This could be attributed to accumulation in the pre-equilibrium state. These results indicate that the background levels can be lowered close to those of dynamic-SIMS by using an extremely high sputtering rate in dual-beam TOF-SIMS.     

A posteriori error analysis of a quadratic finite volume method for nonlinear elliptic problems

In this article, we construct and analyze a residual-based a posteriori error estimator for a quadratic finite volume method (FVM) for solving nonlinear elliptic partial differential equations with homogeneous Dirichlet boundary conditions. We shall prove that the a posteriori error estimator yields the global upper and local lower bounds for the norm error of the FVM. So that the a posteriori error estimator is equivalent to the true error in a certain sense. Numerical experiments are performed to illustrate the theoretical results.     

Second moment of error term of mean value for binary Egyptian fractions

We study the mean square of the error term of the mean value for binary Egyptian fractions.We get an asymptotic formula under the Riemann Hypothesis.     

More efficient time integration for Fourier pseudospectral DNS of incompressible turbulence

Time integration of Fourier pseudospectral DNS is usually performed using the classical fourth-order accurate Runge-Kutta method or other second- or third-order methods, with a fixed step size. We investigate the use of higher-order Runge-Kutta pairs and automatic step size control based on local error estimation. We find that the fifth-order accurate Runge-Kutta pair of Bogacki and Shampine gives much greater accuracy at a significantly reduced computational cost. Specifically, we demonstrate speedups of 2× to 10× for the same accuracy. Numerical tests (including the Taylor-Green vortex, Rayleigh-Taylor instability, and homogeneous isotropic turbulence) confirm the reliability and efficiency of the method. We also show that adaptive time stepping provides a significant computational advantage for some problems (like the development of a Rayleigh-Taylor instability) without compromising accuracy.     

一种非正交对称条带束流位置监测器设计

介绍了一种条带束流位置监测器(BPM)的设计与仿真方法。在国家同步辐射实验室"太赫兹近场高通量材料物性测试系统"工程项目中,针对波荡器出口处真空室非正交对称性的问题,设计了矩形真空室和跑道形真空室下的两种非正交对称性条带BPM,并与传统的圆形真空室下条带BPM进行对比。基于边界元法,利用MATLAB软件分别对三种真空室下的条带BPM进行建模和仿真。仿真结果表明:相对于传统的圆形真空室下条带BPM,矩形和跑道形真空室下条带BPM灵敏度提高了30%,阻抗匹配误差相对降低了20%,束流位置拟合误差降低了80%。考虑加工精度,矩形真空室下的条带BPM更适用于该工程。     

皮肤组织容积脉搏波400~1000 nm光谱特性仿真研究

根据皮肤组织解剖结构特性建立了六层层状模型,并给出了皮肤组织各层的特性参数;考虑了氧合血红蛋白和还原血红蛋白的吸收特性,依据皮肤组织各层的水、血、脂肪、血氧饱和度含量以及血管大小给出了皮肤组织各层的光谱吸收系数;对不同波长散射系数做了适当简化,给出了皮肤组织各层的光谱散射系数。利用蒙特卡罗方法仿真血管组织在收缩与舒张两种状态下, 400~1 000 nm波长光在皮肤组织多层模型中的传输过程,并通过统计大量光子的分布特性,获得了皮肤组织光谱反射系数,并利用模拟所得的两种状态下的反射系数计算得到了光谱容积脉搏波幅度。仿真结果表明,当入射光强一定时,绿光的容积脉搏波幅度优于红光和蓝光。通过计算不同波长光沿皮肤组织深度方向光能流率衰减为1/e时对应的皮肤组织深度,获得了皮肤组织光谱穿透深度。结果显示,血管舒张状态下蓝光和绿光的穿透深度较小,蓝光大部分只能达到表皮层,绿光能到达微循环层,红光可直达真皮层。考虑到光在皮肤组织中传播包含了一个从收缩到舒张的动态过程,基于此,根据穿透深度定义了脉搏波信号产生深度,利用血管舒张与收缩两种不同状态下的穿透深度计算得到了光谱产生深度。结果表明,不同波长光产生深度大于其穿透深度,蓝光产生深度较浅,且其受到的血液吸收调制较小,因而其获得的脉搏信号易受噪声干扰;红光的容积脉搏波产生深度较大,但是相比于绿光其受血液吸收调制较小,且绿光产生深度足够达到真皮血管层,因而红光容积脉搏波的幅度小于绿光。上述仿真结果明确了皮肤组织部分光谱特性,为皮肤组织多光谱容积脉搏波的精确获取及其他相关研究提供了一定的理论基础。     

Study of water uptake in poly(ether ether ketone) irradiated by MeV O+ and Au+ ions

Poly(ether ether ketone) (PEEK) was irradiated with 4?MeV O⁺ and 5 and 10?MeV Au⁺ ions to the fluences from 10¹² to 10^14?cm^?2 and then treated in 5 M/l water solution of LiCl for one month at room temperature. After drying and removal of LiCl surface contamination, the depth distribution of LiCl embeded in PEEK was measured by the neutron depth profilig method (NDP) sensitive to ⁶Li isotope. Embeded LiCl is believed to map distribution of water diffusing into PEEK interior. The results show that the PEEK irradiated to the fluences above 1.10¹³cm^?2 is prone to water penetration to the depths of few microns. On the pristine PEEK and that irradiated to lower ion fluences only a surface Li contamination is observed.     

FT-IR surface analysis of poly [(4-hydroxybenzoic)-ran-(2-hydroxy-6-naphthoic acid)] fiber – A short review

Instrumental techniques such as Fourier Transform Infrared Spectroscopy (FT-IR) constitute well-studied methodologies for polymer characterization, including polymeric fibers. However, a relatively short number of scientific publications involve the characterization of commercial Poly [(4-hydroxybenzoic)-ran-(2-hydroxy-6-naphthoic acid)] (Vectran™) fiber and its surface species. The majority of the published infrared studies uses the medium infrared region (MIR) associated to the Attenuated total reflection (ATR) method. In this scenario, this short review addresses the characteristics of Vectran™ fiber, sample depth data of each FT-IR spectrum mode, reflection and photo-acoustic spectroscopy (PAS), including near infrared (NIR) analysis. This paper addresses also researches on the characterization of Vectran™ by several FT-IR analysis conditions aiming to contribute to future studies. This brief review deals with methodologies developed in the last decade and published by several scientific research groups, emphasizing studies conducted in the last five years. A critical assessment and trends are also included.     

A study of properties of adaptive quadratic grids for three-dimensional near-surface field computations

Curved geometries and the corresponding near-surface fields typically require a large number of linear computational elements. High-order numerical solvers have been primarily used with low-order meshes. There is a need for curved, high-order computational elements. Typical near-surface meshes consist of hexahedral and/or prismatic elements. The present work studies the employment of quadratic meshes that are relatively coarse for field simulations. Directionally quadratic high-order elements are proposed for the near-surface field regions. The quadratic meshes are compared with the conventional low-order ones in terms of accuracy and efficiency. The cases considered include closed surface volume calculations, as well as computation of gradients of several analytic fields. A special method of adaptive local quadratic meshes is proposed and evaluated. Truncation error analysis for quadratic grids yields comparison with the conventional linear hexahedral/prismatic meshes, which are subject to typical distortions such as stretching, skewness, and torsion.